Dinosaur Cards
- You will need
- 1 A4 Sheet of light green coloured card
- 1 A4 Sheet dark green coloured card
- 1 A4 Sheet of white card
- 1 A4 sheet of white paper
- Basic Grey Dino Stamp set
- Ink Pads
- Scissors
- Paper Cutter
- Double sided glue
- Sticky pads
- Card Blank
1. Stamp one of the dinosaurs in dark green on the light green paper.
Leave lots of space in between them.
Make sure you stamp some of the dinos going off the page.
2. Stamp a different dinosaur in brown in the spaces between the green dinos
3. Stamp some footprints walking around the dinos in dark brown ink
4. Stamp some cross bones using red ink
To Make this card
1. Cut a piece of dark green paper 6.5cm deep
Turn the strip you have cut round and cut it 12.5cm long
Put double sided tape on the back of it
2. Cut a piece of light green dino paper 6cm deep
Then turn the strip round and cut it 12 cm long
Put double sided tape on the back
3. Peel off the ds tape on the dino paper
Stick the dino paper to the dark green paper so that a bit of
dark green shows at the top and the bottom
4. Peel off the ds tape on the dark green paper
stick it onto the card blank
5. Stamp dino tracks on the bottom of the card using brown ink
Stamp some footprints on the top of the card.
To make this card
1. Cut a piece of dark green card 12cm deep
Turn it round and cut it 12cm wide
Put DS Tape on the back
2. Cut a piece of your dino paper 11.5cm deep
Turn it round and cut it 11.5cm wide
Put DS tape on the back and stick it in place on the dark green
paper
Stick that onto your card blank
3. Cut a piece of dark green card 6.5cm deep
Turn it round and cut it 12cm wide
Put DS Tape on the back
4. Cut a piece of white card 6cm deep
Turn it round and cut it 12cm wide
Stamp one dinosaur as if it is walking onto the card in brown ink
Stamp another dinosaur as though it is walking off the card using
green ink
Then stamp the dino tracks stamp.
5. Put DS Tape on the back of the card you have just stamped
Stick it to the dark green strip of card
Stick this in place on your card
To make this card
1. Cut a piece of dark green card 12cm deep
Turn it round and cut it 12cm wide
Put DS Tape on the back
2. Cut a piece of your dino paper 11.5cm deep
Turn it round and cut it 11.5cm wide
Put DS tape on the back and stick it in place on the dark green
paper
Stick that onto your card blank
3. Cut a piece of dark green card 6.5cm deep
Turn it round and cut it 12cm wide
Put DS Tape on the back
4. Cut a piece of light green card 6cm deep
Turn it round and cut it 12cm wide
Stamp the Dinosaur Tracks at one side of the card
Put DS Tape on the back
Stick it in place on your card
7. Stamp a dinosaur on white card and cut it out
Stick it onto the card with sticky foam pads